Both driven and bored piles are supported by PileLAT program and the following cross section types can be used in the analysis of single piles under lateral loading:
Driven Piles:
· Circular Section;
· Rectangular Section;
· Octagonal Section;
· H Section;
· Pipe Section; and
· User-defined Section
Bored Piles or Drilled Shaft:
· Circular Section;
· Rectangular Section; and
· User-defined Section

The inputs for the pile properties including different installation and cross section types can be accessed from the sub-dialog at the left side of PileLAT program interface as shown in the figure below.